3 1/8"
79.4
4 9/32"
108.8
9 1/16"
230
1 1/2"
38.1
3/4"
19
3/8"
9.6
19 7/8"
504.8
CENTERLINE
OF HINGE
NOTE
: AN OPTIONAL
MOUNTING PLATE
(5917) IS REQUIRED
WHERE THE HEAD
FRAME FACE IS
LESS THAN 3-1/2"
23 1/4"
590.6
5 3/4"
146.1
8 3/8"
212.7
5 3/4"
146.1
11 5/8"
295.2
9 1/16"
230
3/4"
19
2 1/2"
63.1
Center Track On
Frame Soffit
Installation Sequence:
Use template to locate holes on door and frame. Drill 1/8" pilot holes for the self tapping screws.
1.
Determine door width, adjust spring power of closer by referencing closer installation instructions.
2.
Fasten closer body to frame with power adjustment nut away from hinge.
3.
Fasten slide track to door face with open side facing up and with hold open stop end toward
4.
hinge edge of door.
Place slide arm on pinion shaft of closer at preload of 45 degree angle out from door face.
5.
Secure arm with arm washer and arm screw.
6.
Secure other end of slide arm to track by screwing it to the slide insert. Open door to required
7.
opening angle. Then slide stop only/hold open stop up against slider insert and tighten down the
stop only/hold open stop via set screw.
INSTALL TRACK ARM - TOP JAMB (PULL SIDE) MOUNTING APPLICATION (RIGHT HAND SHOWN) 180 TEMPLATE
Installation Sequence:
Use template to locate holes on door and frame. Drill 1/8" pilot holes for the self tapping screws.
1.
Determine door width, adjust spring power of closer by referencing closer installation instructions.
2.
Fasten closer body to door with power adjustment nut away from hinge.
3.
Fasten slide track to frame face with open side facing down and with hold open stop end toward
4.
hinge edge of door.
Place slide arm on pinion shaft of closer at preload of 45 degree angle out from door face.
5.
Secure arm with arm washer and arm screw.
6.
Secure other end of slide arm to track by screwing it to the slide insert. Open door to required
7.
opening angle. Then slide stop only/hold open stop up against slider insert and tighten down the
stop only/hold open stop via set screw.
INSTALL TRACK ARM - PUSH SIDE APPLICATION (RIGHT HAND SHOWN) 120 TEMPLATE
NOTE: IF USER
WISHES
TO HAVE A
LESSER
SWING ANGLE,
SIMPLY
MOVE HOLD
OPEN STOP
OR STOP ONLY
AWAY FROM
THE PIVOT
HINGE IN
INCREMENTS
OF 1/2" UNTIL
DESIRED
ANGLE IS
ACHIEVED.
NOTE: IF USER
WISHES
TO HAVE A
LESSER
SWING ANGLE,
SIMPLY
MOVE HOLD
OPEN STOP
OR STOP ONLY
AWAY FROM
THE PIVOT
HINGE IN
INCREMENTS
OF 1/2" UNTIL
DESIRED
ANGLE IS
ACHIEVED.
HINGE CENTERLINE ON
BACKSIDE OF DOOR
Page 2 of 3
REV: 1 REV DATE: 1/11/2014
5300 Series Track Arm
Installation Instructions
I-CL00579
