9
OPERATION MANUAL
2.2 SPECIFIC SAFETY FOR BAND SAWS
DO NOT use this machine unless you have been instructed in its safe use and
operation and have read and understood this manual
Safety glasses must be
worn at all times in work
areas
Long and loose hair must
be contained.
Gloves must not be
worn when using this
machine.
Sturdy footwear must be
worn at all times in work
areas
Close fitting/protective
clothing must be worn
Rings and jewelery must
not be worn.
PRE-OPERATIONAL SAFETY CHECKS
P
Ensure no slip/trip hazards are present in workspaces and walkways.
P
. Check that all guards are in position.
P
Ensure hydraulic damping mechanism functions.
P
Check that the blade is in good condition.
P
. Ensure that blade speed, blade tension and blade tracking are properly adjusted.
P
Check coolant delivery system to allow for sufficient flow of coolant.
P
. Locate and ensure you are familiar with the operation of the ON/OFF starter and E-Stop.
P
Faulty equipment must not be used. Immediately report suspect machinery.
OPERATIONAL SAFETY CHECKS
P
Lift the head of unit up and lock it in the upward position.
P
Set the angle of the vice, or check it to ensure its squareness.
P
Clamp work piece firmly into the vice. Long material must be supported.
P
Adjust blade guards to cover unused portion of blade.
P
Ensure hands are away from the blade, and then turn the machine on.
P
Allow the upper head assembly to come down slowly until the teeth are cutting the material.
P
Keep hands away from the point of operation during cutting.
P
Turn off the machine and bring it to a complete standstill if the blade is to be lifted out of an
uncompleted or jammed cut.
P
Stop the machine and bring it to a complete standstill before removing scrap pieces from
the vice area or making adjustments.
P
Stop the saw immediately if the blade develops a ‘click’. Report it to your teacher.
P
Ensure the cutting head is locked in the upward position before removing work piece.
AFTER OPERATION
P
Switch off the saw and reset all guards to a fully closed position.
P
Leave the machine in a safe, clean and tidy state.
DO NOT
Pushing down on the cutting head while it is cutting
Leaving the machine running unattended
