20
OPERATION MANUAL
To adjust the side Rollers
1. Loosen the lock nut on the top of eccentric bolt. (Fig.6.3)
2. Using a spanner on the hex section between the
bearing and the casting, adjust the bearing, so it is
against the side of the blade. There should be no
clearance. (Fig. 6.4)
3. Tighten the lock nut making sure that the eccentric
bolt does not turn.
4. Adjust the other ball bearing guide.
5. Repeat steps 1-4 on the other set of ball bearing guides
on the opposite side of the saw bow.
F
ig
. 6.3
L
ocK
n
ut
SAW BLADE DOES NOT CUT SQUARE.
Check to see if the saw blade is cutting square. If the blade is
not cutting square as per the example (Fig. 6.5)
1. Replace with a new blade and check for squareness. The
workpiece should be as per Fig. 6.6
2. Inspect the blade guides to see if there is a gap between
the bearings and the blade (Fig.6.7)
F
ig
. 6.5
F
ig
. 6.6
F
ig
. 6.7
F
ig
. 6.4
L
ocK
n
ut
H
ex
s
ection
