Hafco Metalmaster BS-321AS, Instruction Manual

Page: 8 / 27

3
2.5 Install the outlet tray, length stop device
and mobile coolant trays.
Install the outlet tray and stop bar on to the
machine after setting up the machine already as
below steps:
1. Assemble the new outlet tray on to the
machine by screw in the four screws on the
both side as picture. Tighten the four screws
after make sure the top of outlet surface same
as table.
2. Install stop device on to the outlet tray at the
right side.
3. Install the mobile cover to the four slots and
push it to the right side to secure it.
4. They are two mobile coolant trays can be
moved and used in miter cutting on front and
rear side to prevent coolant spray on to the
floor.
2.6 Securing to foundation
Position the machine on a flat and level
foundation of reinforced concrete. Level machine
and anchor it to the foundation with anchor bolts.
Maintain a minimum distance of 800mm from the
rear of the machine to the wall. Position the
anchors using screws and expansion plugs or tie
rods sunk in cement.
2.7 Leveling the machine
The operating accuracy of all precision machinery
depends on the accuracy of the installation of the
machine. Manufacturing tolerance of the machine
can only be guaranteed if the machine is firmly
and properly installed. Once the machine is
lowered on the prepared foundation, machinist
levels should be used alternately on the vice slide
plates and work feed table, adjust the left to right
and front to back level of the machine with
leveling bolts.
When leveling left to right level, adjust left side to
be approximately 3mm higher than the level of the
right side. This will provide proper return of the
cutting fluid. After proper leveling of the machine,
use anchor bolts to secure to the foundation.
Caution: All leveling bolts should support the
weight the machine evenly.
2.8 Deactivation of machine
If the machine is to be out of use for a long period,
it is advisable to proceed as follows:
1) Disconnect from the power supply
2) Loosen the tension on the blade
3) Release the bow return spring
4) Empty the coolant tank
5) Carefully clean and grease the machine
6) If necessary, cover the machine.
Dismantling
(due to deterioration and/or
obsolescence)
As a General Rule,
If the machine is to be permanently demolished
and/or
scrapped, divide the material to be
disposed of according to type and composition, as
follows:
1) Cast iron or ferrous materials
, composed of
metal alone, are secondary raw materials, so
they may be taken to an iron foundry for re-
smelting after having removed the contents
(classified in point 3).
2) Electrical components, including the cable and
electronic material (magnetic cards, etc.), fall
within the category of material classified as
being assimilated to urban waste according to
the laws of your local, state, or federal
government, so they may be set aside for
collection by the public
waste disposal service;
3) Old mineral and synthetic and/or mixed oils,
emulsified oils and greases are considered
hazardous or special refuse, so they must be
collected, transported and disposed of at a
special waste disposal service.
NOTE: The
standards and legislation concerning
refuse is in a constant state of evolution, therefore
is subject to changes. The user must keep
informed of the regulations at the time of disposal
as these may differ from those described above.
Mobile coolant tray
Outlet tray
8 Instruction Manual for BS-321AS (B034A) 31/03/2016