Hafco Metalmaster BS-321AS, Instruction Manual

Page: 14 / 27

9
- Turn the power off and recheck the blade
tension and chip brush. If further adjustment is
necessary disconnect the saw from the power
source, make adjustments, and re-connect the
power.
5.8 Laser guide device (optional)
The laser guide has been set correctly before
shipment. The laser guide - line works when
machine power on, the red line will align and close
with the blade.
If any situations have to readjust Laser device,
see below pictures.
- A screw for moving the device forward or
backward.
- B screw for moving the device downward or
upward.
- Loosen C thumb knob for adjust the device
angle.
5.9 Install the vertical press on the vise jaws
for bundle cutting (optional)
- Standard press capacity (W x H) 250~485 x
150~240 mm. Vise plates height 240 mm
- Special press capacity (W x H) 250~485 x
300~400 mm. Vise plates height 400 mm
- Open the vise more than 250mm.
- Attach and Tighten posts bolts’ (A) on to vises.
Then attach the vertical press to the top of the
post bolts. Connect the Hydraulic connector (B).
- Attach the nuts (H) on to the posts, but do not
make the nut (H1) on moveable vise jaw too
tight. *Otherwise, the vise won’t be able to
clamp the work piece or the post bolts will be
damaged.
- Adjust the vise press (E) to sit approximately 5-
8mm above the work piece. Loose nut (C) and
rotate the bolt (D) to raise or lower the vise
press (E).
- Adjust the vise press width to fit the work piece
size. Loosen screws (F) on both sides of the
vise press then move press extender bars (G)
desired width.
- Turn OFF the hydraulic pump.
- Attach the hydraulic hose to connecter (B) and
then attach the quick link connecter (J) to the
90-degree fitting.
- Switch ON the hydraulic pump.
6 OPERATION CYCLE
6.1 Operation cycle
- Turn on the main connect. on the door of
electrical box. Then the Power indicator (A) will
light up.
- Start the hydraulic system, use button (D).
- Turn Switch (L) to Manual mode
- Raise the saw bow, Use bow up button (H).
- Open the vise, use vise open button (J)
- Load the working material.
Laser guide device
C
A
B
H
D
C
H1
A
E
F
G
B
J
A
B
C
D
F
G
H
I
J
K
E
L
14 Instruction Manual for BS-321AS (B034A) 31/03/2016