HAEGER Digiglass, User Instructions

Page: 6 / 40

English - 4
3. Green tea: Shortly press this button to select the preset temperature of 80
°
C.
4. Freshly ground coffee: Shortly press this button to select the preset temperature
of 90
°
C.
5. Boiling water/infusions: Shortly press this button to select the preset
temperature of 100
°
C. The three buttons all light on. The temperature
icon shows the current real time temperature and enter boiling status. After boiled the
Warm and Boil buttons will light off and the temperature show will be off after 30
seconds. The Power button will switch to breath light.
6. Temperature increase / decrease buttons: single press / . The temperature
range is from 40
°
C to 100
°
C in the 5
°
C steps.
7. Keep Warm : press the Warm button to activate the function. The light will be in
twinkle status. Select the required temperature by pressing the increase or decrease
button or selecting directly the 70, 80 or 90 button and automatically enter the keep
warm state. The keep warm time is 2 hours. When the water temperature is lower than
the set value of about 5 degrees, the heat will be resumed until 2 hours.
Note: if you
press Warm button by mistake the function will be cancelled.
8. Power button: in the power state, the power button indicator will light up. If there is
no operation within 1 minute, the kettle will automatically enter the standby state, and
the power button light will be changed into the breathing light (in the standby state,
only press the power button is effective, other keys are invalid, and enter the setting
state. To switch to setting mode, you need to press the power button again.
9. Memory function: In the keep warm mode, after boiling water to the set temperature,
the function of memory starts. Within a period of ten times of lifting the kettle, the
function continues to work if the temperature of the water in the kettle does not drop
by less than 8 degrees below the set value. Otherwise, it exits the keep warm function.
Cleaning
WARNING:
−
Always turn the device off before cleaning it and remove the mains plug. Wait until the
device has cooled down.
−
Never immerse the device or the base in water or other liquids.
CAUTION:
−
Do not use any wire brush or other abrasive objects.
−
Do not use any acidic or abrasive detergents.
−
Rinse the water container out with clean water. Then dry it off with a cloth.
−
Clean the housing after use with a slightly damp cloth.
Descaling
Your kettle should be periodically descaled as the mineral deposits in tap water may
form scale on the bottom of the kettle so as to cause the operation less efficient. You