HADEF 70/06AP, Installation, Operating And Maintenance Instructions

Page: 17 / 29

5.52.541.00.01.06
17
Pos : 12.2.3 /1_H ADEF /---ALLG EMEIN/Hinweis e/ GEF AHR - Losreiß en, Pers onentr.,s chweb. Las ten, ex ver boten ( E+P) @ 0\ mod_1176799462104_52. doc x @ 4735 @ @ 1
DANGER!
It is not allowed:

pulling loose of stuck loads, dragging of loads and inclined pulling is not allowed.

in explosive atmosphere, except the unit is especially modified for it and marked by an indication label

to transport people

The device is not suitable for use on stages and in studios

persons must not stand under a suspended load
Pos : 13.1 /1_H ADEF /9--IN BETR IEBNAHM E/ *Ü1* /#. Kapit el - I nbetri ebnahme @ 0\ mod_1177486166685_52. doc x @ 5393 @ @ 1
9 Commissioning
Pos : 13.2.1. 1 /1_H ADEF /9--IN BETR IEBNAHM E/ Allgemei n/ Allgemei n/ 01.Allgemein @ 0\ mod_1172504961658_52.doc x @ 355 @ @ 1
9.1 General
Should the unit be used in Germany:
Please observe the validated, national accident prevention regulations.
For other countries:
Inspections as above. Please observe the national rules and regulations and the instructions in this manual!
Pos : 13.2.1. 2 /1_H ADEF /---ALLG EMEIN/Hinweis e/ Prüf ungen/HIN WEIS - Pr üf ung durch bef ähigt e Pesonen @ 0\ mod_1177339966681_52. doc x @ 5319 @ @ 1
NOTICE!
Hoists up to 1000 kg capacity and without motor-
driven trolleys of hoisting unit must be tested by a “qualified
person” before putting into operation for the first time.
Hoists of 1000 kg capacity and up or with more than one motor-driven hoist movement; i.e. lifting and trolley
movement, must be tested by a “licensed qualified person” before putting in operation.
An exception is “hoists ready for operation” acc. validated national regulations with EU
-declaration of
conformity.
Definition “qualified person”
(former expert)
A “qualified person” has learned, due to occupational training and experience and the job that the person has
done, the skills needed to tests the material for one’s work.
Definition “licensed qualified person” (former approved expert)
A “licensed qualified person” has, due through special occupational training, knowledge about testing of the
material for one’s work and knows the national accident prevention regulations and other prescriptions and
technical regulations. This person must tes
t the material for one’s work regularly with regard to design and
kind of use. The license will be given to qualified person be the approved supervision authorities (ZÜS).
Pos : 13.2.2. 1 /1_H ADEF /9--IN BETR IEBNAHM E/ Allgemei n/Dr uc kluft ans chl uss/ Alle @ 1\ mod_1185782523360_52.doc x @ 7441 @ @ 1
9.2 Compressed air connection
Before commencing work on the equipment, the main air supply line must be closed and secured against
inadvertent opening!
9.2.1 Main connection

The connections must be made according to the pneumatic connection diagram.

Connect to the existent hose nozzle.

The hose must be secured with a hose clamp.
Nominal width of the air connection hose
0,52-0,75 kW - NW 13 mm
1,5 kW - NW 19 mm
2,5 kW - NW 25 mm
If hose length exceeds 15 m, a larger cross section must be selected.
9.2.2 Control hose connection
Control switches with hoses are connected at the factory, unless otherwise agreed.
Pos : 13.2.3. 1 /1_H ADEF /9--IN BETR IEBNAHM E/ Allgemei n/ Wartungsei nheit /All e G eräte @ 1\ mod_1193055355138_52.doc x @ 8102 @ @ 1