02.
PREPARE THE BOW LIGHT
01
02
Insert one of the plugs
19-07
into the top end of
the
19-09
jackstaff (the end that is further away
from the notch, see inset). The second plug
19-07
is a spare.
Place the forward deck assembly upside down
on your desktop, taking care not to cause any
damage. Fit the fibre optic guide
19-04
between
the raised shapes near the bow, as shown.
Thread the other end of the fibre optic cable
19-10
through the opening in the jackstaff
19-09
.
Push the cable down the jackstaff so that it
comes out of the open end (see curved arrow).
The straight arrow indicates where the knot is.
Take the fibre optic cable
19-10
and make a knot
near one end. This will form the lamp at the
bow, so pull it quite tight (see inset).
Pull the fibre optic cable
19-10
through the
jackstaff
19-09
so that the knot sits in the
opening. (Make sure that the knot is not so small
that it can slip through
the opening.)
Cut off the short end of fibre optic cable
19-10
directly above the knot (the arrow indicates
where the knot is).
19-10
1-01
19-04
19-09
19-07
19-10
19-09
19-10
19-09
19-09
19-10
03
04
05
06
19-08:
LED cable
19-09:
Jackstaff
19-10:
Fibre optic cable
PB:
Two 2 x 4 mm screws
37
36
AGORA
MODELS
37
AGORA
MODELS
