Hach sension6, Instruction Manual, Page: 36 / 86

35
SECTION 3,
continued
Accessing the calibration mode or the setup mode halts automatic
data transfer. Also, if the meter has been set to the Lock mode
using setup 1, the meter will not send data. When the meter is in
Lock mode and the
READ
key is pressed, automatic data transfer
will occur at selected time intervals only until the meter stabilizes
and the value in the display is locked.
To change the automatic data transfer setup:
1. Press the
SETUP/CE
key.
2. Press the up arrow nine times. A
10
will begin flashing in the
upper right hand corner of the display. The current automatic
data transfer entry will be displayed.
3. Press the
EXIT
key to leave the value unchanged. To change
the value, press the
READ ENTER
key. The flashing question
mark will appear in the upper right corner of the display next
to the 10. Use the arrow keys to view the time intervals for
automatic data transfer.
4. Press the
READ ENTER
key and then the
EXIT
key when the
desired automatic data transfer time interval appears in the
display. The meter will return to the Reading mode.
Each time data transfer occurs, the Print icon will momentarily
appear at the top of the display.
To turn off automatic data transfer:
1. Access setup 10 as described above.
2. Press the
READ ENTER
key.
3. When the question mark is flashing next to the 10, press the
down arrow until
(off)
appears in the display.
4. Press the
READ ENTER
key.
5. Press the
EXIT
key. The meter will return to the Reading mode
and automatic data transfer will no longer occur.