Hach SC4500, User Instructions, Page: 8 / 112

2.3 Product components
Make sure that all components have been received. Refer to Figure 1 . If any items are missing or
damaged, contact the manufacturer or a sales representative immediately.
Figure 1 Product components
1 Strain relief, washer and nut 3 USB box
2 USB box connection cable 4 Pole mounting hardware
2
Section 3 Installation
3.1 Mounting
N O T I C E
Use the mounting holes to install the USB box. Do not make holes in the rear of the USB box or
damage to the internal components can occur.
N O T I C E
Close the USB box cover and make sure that the cover screws are tight to keep the
environmental rating of the enclosure.
Install the USB box in a location where the power disconnect device for the controller is easily
operated. Install the USB box in the location with the highest cellular signal strength. Use a mobile
device with the same cellular service provider as the SC4x00 controller to find the location with the
highest cellular signal strength.
Attach the USB box to a wall, vertical pole or horizontal pole.
Note: Wall mounting hardware is supplied by the user. Screws/fittings must be suitable for the wall/ceiling
properties and possess sufficient bearing capacity.
2
The pole mounting hardware is for a 40–mm (1.57–inch) diameter pole.
8 English