10
4. Wheels with an addi�onal PU layer and a locking system.
5. The lumbar sec�on adjustment system based on 2 gas springs enabling:
- up / down movement (�l�ng) in the range of -40 ° to 22 °;
- lateral movement (swing) in the range -18 ° to 18 °.
6. The headrest adjustment system based on a gas spring that enables:
- up / down movement (�l�ng) of the en�re frame headrest in the range of -40 ° to 30 °;
- addi�onal movement of the headrest itself in the range of 0 ° to 30 °.
7. A system that enables trac�on for the cervical and lumbar spine in the total range of 13 [cm].
8. A system that enables the "drop" technique to be carried out on the lumbar, thoracic and cervical spine.
9. Armrest adjustment system in the range of 0-20 [cm].
Width: 56 [cm]
Length (depending on the user se�ng): 185 [cm]
Height (depending on user se�ngs): 55 - 97 [mm]
Weight: 130 [kg]
Loading capacity: 200 [kg]
Power supply: voltage 230V, 50 / 60Hz, output 5V 1A
V. INSTALLATION
1. Unpacking.
Unpack the table. Check that it has not suffered any damage during transport. If it is damaged, do not connect
it and no�fy your dealer.
2. Connec�on to the power network.
Before inser�ng the plug into a power outlet, make sure that:
- the socket is properly grounded and complies with the applicable regula�ons;
- the socket is able to withstand the maximum power load of the device, as given in the Technical Data point;
- the voltage of the electric current in the network is consistent with the data given in the Technical Data
point;
- the socket corresponds to the plug. If not, replace the socket.
Do not install the devices in the open air. Electric actuators may work not longer than 2 minutes.
Restart is possible a�er 18 minutes of rest. A�er installa�on of the table the mains socket should be
easily accessible. Do not use the extension cords. The cable should not be bent. The cable of the
power supply may be replaced only by an authorised specialist. No independent repairs of the
electric actuators should be performed. Avoid direct sunlight, UV radia�ons, rain, extensive dust,
moisture.
A�en�on!
The manufacturer bears no responsibility for the product if the above-men�oned rules are not
followed.