Habasit PQ-01, Use And Maintenance Manual

Page: 8 / 34

Habasit Italiana S.p.A.
Via del Lavoro 50
I-31016
– Cordignano (TV)
Tel.: +39 0438 9113
Fax: +39 0438 912374
Use and maintenance manual
W-01
Author: FT Page 4 of 15
Edition: 06/2017 R. 0
Replaces:
0 Introduction
The welder W-01 is a device for welding of thermoplastic round belts (Polycord).
Its use is expected in combination with the devices CQ-01 and CQ-02 specifically dedicated to the
positioning of the thermoplastic round belts.
With W-01 are indistinctly indicated the models:

W-01/6 for 120V power voltage

W-01/8 for 230V power voltage
1 General information
1.1 Application
The welder W-01 was specifically designed for a rapid and safe welding of thermoplastic round belts up to a
diameter of 15 mm / 0,6 in. in combination with the positioning devices CQ-01 and CQ-02.
The welder W-01 is manufactured according to recognized engineering principles and state of art
technology, and complies with applicable regulations.
These operating instructions imply that all assembly, maintenance, and repair work, as
well as operation of the welding device, be carried out by SKILLED/QUALIFIED
PERSONNEL or monitored by responsible specialists.
For reasons of scope, these instructions cannot cover all possible aspects of operation,
maintenance, or repair. The indications given herein refer to the use of the machines
according to their designated purpose by skilled personnel.
In case of doubt or if further detailed information is required, please consult the
manufacturer.
1.2 Important safety terms
Symbols WARNING and INDICATION were included in this manual.
These symbols indicate hazards or special instructions to be observed.
WARNING Serious injury and/or serious material damages may ensue if ignored.
INDICATION Indicates important technical information that may not be known to even
expert personnel.
1.2.1 General warnings
Read all hazard warnings and operating instructions.
Failure to observe the hazard warnings and operating instructions may lead to electrical shock, fire and/or
serious injury hazards.
The tool power plug must be suited to the socket. Strictly avoid modifying the plug. Do not use adapter plugs.
Unmodified plugs and sockets suited for the purpose reduce electrical shock risks.