Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Regulating Unit PMR-07
Author:
A.T. / KM
CONTROL UNIT
Edition: 04/2006
Page
E-6
Replaces: 10/2005
E.2.3
I
NTERRUPTING THE JOINING CYCLE
When the joining cycle is interrupted with the [STOP], button, various courses of action can be
taken. Which ones are possible depends on the current phase of the joining cycle:
Ph2
Ph1
Ph3
Ph4
Press [STOP] to interrupt the joining cycle.
Æ
Red [STOP] and green [START] indicators blink.
Æ
Power to all components of the hot pressing device is shut off [no cooling, no heating]
Æ
The display shows the phase of the joining cycle to which the control will proceed when
[START] is pressed.
Select the desired phase with the [UP] and [DOWN] arrow keys.
Resume the cycle in the selected phase by pressing [START]
or
Leave the joining cycle altogether by pressing [STOP] again. In this case the press has to cool
down on its own.
So the following exit paths are possible:
Phase 1 (heating up, below cooling end-temperature) to Standby
Phase 2 (heating up, above cooling end-temperature) to Phase 4 or Standby
Phase 3 (count down of pressing time) to Phase 4 or Standby
Phase 4 (cooling) to Standby
CAUTION
Opening the press before cooling down temperature is reached may have a
negative impact on joining quality.
Regulating Unit PMR-07