ES0609 rev D 4/09
24
Minor
– Enter minor diameter of threads (smallest part of the thread (Min Diameter). Cannot be negative.
Major
– Enter major diameter of threads (largest part of the thread (Max Diameter). Cannot be negative.
Manually measure the diameter of the work piece at the point where “X Dia Meas” was pressed.
TPI
(Threads per Inch) – Enter number of Threads per Inch (how many threads to cut per inch of length).
Depth of Cut
– Enter the amount of stock to be removed on each pass. Must be less than or equal to the
maximum single pass cut depth for the selected tool.
Spindle RPM
– Enter the spindle RPM. This is the commanded spindle speed.
Taper
– Enter a positive value for thread taper per ft.
Thread Dir
– Enter ‘0’ for right hand threads or enter ‘1’ for left hand threads.
Chamfer
– ‘ON’ turns on chamfer at end of threads. ‘OFF’ turns off chamfer at end of threads. (Check setting
95, 96, 86, 99).
Coolant
– ‘ON’ turns on machine coolant. ‘OFF’ turns off machine coolant.
Advanced Users:
Additional Settings may need to be modified to create the required groove. These setting
numbers are: 22, 28, 72, 73, 86, 95, 96, 99. See the definitions of the setting in the Operator’s Manual.
In the full CNC mode this is a G76 command.
Threading - ID Thread
This mode is used for cutting inside diameter threads using multiple passes.
Press <CYCLE START> to run
in MDI or <F4> to record
output to a program
TOOL NUMBER
1
WORK OFFSET
54
Z START PT
0.0000 in
THREAD LENGTH
0.0000 in
OD THREAD ID THREAD
OD THREAD REPAIR
ID THREAD REPAIR
MINOR
0.0000 in
0.0000 in
0.000
DEPTH OF CUT
0.0150 in
TAPER
0.0000 in
MAJOR
TPI
SPINDLE RPM
1000
RIGHT
CHAMFER
OFF
THREAD DIR
COOLANT
OFF
GROOVING
THREAD RE-CUT
MANUALSETUP
TURN & FACE
CHAMFER & RADIUS
DRILL & TAP
THREADING
Tool Number
– Enter the tool to be used.
Work Offset
– Enter the work offset to be used.
Z Start Pt
– Enter the Z axis starting point.
Thread Length
– Enter the length of the threaded portion of the part. This value cannot be negative.
Minor
– Enter minor diameter of threads (smallest part of the thread (Min Diameter). Cannot be negative.
Major
– Enter major diameter of the threads (largest part of the thread (Max Diameter). Cannot be negative.
Manually measure the diameter of the work piece at the point where “X Dia Meas” was pressed.
TPI
(Threads per Inch) – Enter number of Threads per Inch (how many threads to cut per inch of length).
Depth of Cut
– Enter the amount of stock to be removed on each pass. Must be less than or equal to the
maximum single pass cut depth for the selected tool.
Spindle RPM
– Enter the spindle RPM. This is the commanded spindle speed.
Taper
– Enter a positive value for thread taper per ft.
Thread Dir
– Enter ‘0’ for right hand threads or enter ‘1’ for left hand threads.
