STEP 13
Push
ZERO RETURN
. Start with the X Axis.
Caution:
If the A axis (tilt) moves more than 20 degrees past the
home position,
Push
[EMERGENCY STOP]
to prevent damage. Make sure
that you selected the correct rotary model for setting
30, 4TH
AXIS ENABLE
and setting
78, 5TH AXIS ENABLE
. If you
selected the correct rotary model and axis, speak to your Haas
Factory Outlet (HFO).
Jog the table to the maximum travel in each axis.
Caution:
Make sure the cables do not get caught on the table or
get crushed between the table and the enclosure to prevent
damage.
Turn ("tilt") A axis to get access to the T-Nuts.
Push
[EMERGENCY STOP]
.
Install the remaining studs, washers and nuts.
Rotary - TR/TRT/T5C - Platter Parameter 212 - Horizontal Adjustment
This procedure tells you how to make the platter parallel to the Y-Axis movement. You change Parameter 212 to make the
platter parallel.
STEP 1
Push
ZERO RETURN
. Push
A
.
Put the magnetic base of a dial indicator on the spindle head.
Jog the X axis to center the platter on the spindle. Jog the Y
and Z axis until the indicator is above the platter edge. Make
sure you can indicate the full diameter from front to back.
Set the indicator to zero. Indicate the platter or collet face along the Y
Axis. If the error is more than 0.0003" (0.008mm) adjust Parameter 212 in
small increments in the positive (+) or negative (-) direction to adjust the
flatness.
Push
ZERO RETURN
. Push
A
.
Do this step again until the error is less than 0.0003" (0.008mm).
Copyright 2020 by Haas Automation, Inc. No unauthorized reproduction | Last Published On December 13, 2016
9/12
