5
Remove the cross-slide way cover [4].
Remove the cover plate [9] for the coolant hose.
Remove the breakout tab [8] from the cover
plate.
Remove the coolant hose assembly [7].
Install the ATT-4 turret [1] onto the (2) outer holes
[5] of the cross-slide.
Install the ATT-8 turret [2] onto the (2) inner holes
[6] of the cross-slide.
Keep the screws sufficiently loose for turret
alignment.
Remove the servo-motor cover [3].
6
Pull the cables and air hoses from the coolant
hose conduit [3].
Install the split conduit with the cables and hoses
into the clamp [8].
Connect the (2) air tubes to the (2) air fittings [4].
Connect the power cable [5], and encoder cable
[7] to the motor. Connect the home switch cable
[6].
Note:
Make sure all electrical connections are
made inside of the motor compartment.
Install the cover plate [9]. Install the cross-slide
way cover [2].
Install the cover for the servo-motor [1].
Install the cover for the upper cable channel and
the top of the enclosure.
7
Install the extension tube [2] and the coolant
hose assembly [1].
Connect the air supply.
Set the main circuit breaker to the ON position.
Push
[POWER ON]
.
TL-1/2 - ATT-4/8 Turret - Installation and Alignment - AD0304
Page 6 of 10 pages
