GB
10
7.3.2.5. Starting the pellet stove - operating mode ON
10:34
Procedure:
On the standard screen, press the
"On/Off"
button to get the stove
started.
Start zone 1
now appears under
"Operating status"
and the start
process begins.
26 °C
23 °C
start zone 1
ON/OFF
menu
Note
By pressing the
"On/Off"
button again, the stove is switched back off.
OFF
then appears under
"Operating
status"
.
The stove performs the ENTIRE start zone, however, until it reaches the necessary flame temperature and
only then switches to the cooling Operating status and then OFF.
WARNING
During the first use, odours may build up for a short time. Please ensure that there is adequate ventilation in
the installation room during this time and avoid inhaling directly!
Note
If the start zone could not be successfully completed i. e. no flame generation or the required temperature
could not be reached at the flue gas thermosensor, then a safety shutdown is initiated and an error message
generated ("Error 2 – Date and time"). Before starting again, empty the burner and replace it.
8. Additional operator console functions
8.1. Backlighting
The backlighting of the display is switched off 5 minutes after the operator console was last operated and
switches to energy saving mode.
The backlighting is switched on by pressing on button. The function buttons are only active once the
backlighting has been activated. The backlighting is also activated by an error message being triggered.
8.2. Energy saving mode - Actual room temperature display
The display energy saving mode is automatically activated after a
few minutes. The display shows Actual room temperature.
Summary of Contents for HSP 8 CATANIA-II-RLU
Page 27: ......
