Helpful Hints
Be sure to always vacuum or sweep up loose dirt before
steam cleaning your floors.
The FS-50 does not have any
suction power.
The easiest way to use the FS-50 is to tilt the handle to
a 45° angle and then push and pull the unit slowly across
each section of your floor – approximately 2 to 3 yards at a time.
To release the handle/pole in preparation for using the
FS-50, simply place your foot gently on top of the main
unit and pull back. Do not to confuse the Orange Power
Button as a release for the handle.
A good amount of steam passes through the Ultra-Microfiber
Pad. We recommend that the Ultra-Microfiber Pad be
changed when it gets too wet. Your FS-50 includes 2 Blue
Ultra-Microfiber Pads. Never leave the cleaning pad on
your FS-50 when you have finished using the unit. Always
remove the pad and wash in cool or warm water with a mild
detergent. Never use bleach or fabric softener. See further
instructions on the care of the cleaning pads on page 13.
While the FS-50 effectively cleans dirt and grime from
sealed hard-surface floors, particularly stubborn stains
on vinyl or linoleum floors may be pre-treated with a mild
detergent and a little water before using the Steam Cleaning
Floor Sanitizer.
Always let the FS-50 Floor Sanitizer cool for at least 5
minutes before removing any of the cleaning pads and
emptying the Water Tank.
Never leave the FS-50 in one spot on any surface for any
period of time. Always place your FS-50 on the black Floor
Protector/Resting Mat (with the “bumpy” side facing up)
when stationary, and make sure the unit is turned off
when not in use.
Do NOT attempt to use the FS-50 in a vertical position (ie:
to clean a tile wall) as this may cause leaking or
malfunction of the product.
pg 14 877-HAAN DIRECT / 877-422-6347
www.
HAAN
USA.com