haacon 1889.5, Operating Manual

Page: 3 / 17

094204_c_gb_hebvrr_v haacon hebetechnik gmbh – Phone +49 (0) 9375 - 84-0 – Fax +49 (0) 9375 - 8466 3
1. Safety instructions
Duty of care of the operator
The lifting device Type 889 has been designed and
built to after the careful selection of the
harmonised standards with which it must comply and
other technical specifications. It is therefore state of
the art and offers maximum safety.
However, this safety level can only be achieved in
practice if all the action required for it is actually taken.
It is a matter for the operator of the lifting device to
plan this action and to check that it is implemented.
The operating must in particular ensure that
the lifting device is only used for the purpose for
which it is design (see the section entitled General).
the lifting device is only operated if it is in perfect
working order and special safety equipment is
checked regularly to ensure that it remains fully
functional.
the operating manual is available at the place of use
of the lifting device at all times in legible
condition.
only suitably qualified and authorised personnel is
allowed to operating, service and repair the lifting
device.
this personnel is instructed at regular intervals in
all matters of industrial safety and environmental
protection and that they are familiar with the opera-
ting manual and the safety instructions contained
there in.
all the safety and warning notices on the lifting
device remain on the device and are kept in legible
condition.
nobody is on, in or under the container with the
mounted lifting device during the lifting or lowering
procedure.
persons only enter the system if the distance bet-
ween the bottom of the container and the ground is
less than 400 mm or load holders are fitted to act as
additional safety devices pursuant to VBG 4.
Basic safety action
To prevent damage and fatal injuries when operating
the lifting device, do not
exceed the maximum (see section entitled Techni-
cal data).
allow people to ride on the device.
work in, on or under the raised load if it exceeds
the maximum height off the ground or load holders
pursuant to VBG 4 are fitted.
–
–
–
–
–
–
–
–
–
–
–
exceed the maximum angle (see section entitled
Other instructions).
set up the device in wind speeds in excess of
64 kph.
You must also ensure that if you wish to lift the maxi-
mum load the centre of gravity of the load is positioned
as centrally as possible between the supports.
Requirements on the operating personnel
The lifting device Type 889 may only be operated by
people who have been trained, instructed and autho-
rised to do so. These people must be familiar with the
operating manual and act accordingly. The authority of
the operating personnel must be defined clearly.
Damage or defects on the lifting device are to be re-
ported to the appropriate person without delay. Do not
work with the lifting device until the damage or defect
has been rectified.
Servicing and repair work
Servicing and repair work may only be completed by
trained personnel.
Do not make any unauthorised modifications to the
lifting device for safety reasons – this particularly
applies to welding work on load-bearing parts. All
planned modifications must be approved in writing by
haacon hebetechnik gmbh.
Only use original spare parts / original wear parts.
These parts have been specially designed for the
machine. If you use other parts it cannot be guaran-
teed that they are designed and built to withstand the
stresses safely. Parts and special equipment that are
not supplied by haacon hebetechnik gmbh have not
been approved for use on the lifting device.
The maintenance work set out in the operating manual
(cleaning, lubrication, servicing, inspection, etc.) must
be completed on schedule.
–
–