2-6
2.
Disassemble the liquid tight adapter (assembled by a weatherproof connector, a sealing nut,
and a rubber seal) and detach the rubber seal, feed the optical fiber through the connector,
and then attach the rubber seal to the cable.
Figure2-8 Feeding the optical fiber through the connector
3.
Insert the rubber seal into the weatherproof connector.
Figure2-9 Inserting the rubber seal into the weatherproof connector
4.
Adjust the weatherproof connector to ensure that the rubber boots of optical fiber reaches out
of the weatherproof connector. Attach a transceiver module to the SFP port of the AP, and
then connect the optical fiber to the transceiver module.
Figure2-10 Connecting the optical fiber to the transceiver module
5.
Adjust the weatherproof connector to ensure that the optical fiber between the liquid-tight
adapter and the optical fiber connector is not bended or folded, and then fasten the
weatherproof connector.
Figure2-11 Fastening the weatherproof connector
6.
Fasten the sealing nut.
Figure2-12 Fastening the sealing nut
7.
Start wrapping at the top of the weatherproof connector until the entire connector is wrapped.
Smooth the tape edges to ensure full adhesion.
