85
Figure 56 Removing the mounting brackets from the chassis (M9006)
3.
Put the mounting brackets into the box.
Removing the cable management brackets
The M9010/M9010-GM gateway has two cable management brackets—the one on the chassis
bottom routes power cords, and the one on the chassis top routes signal cables.
The M9006/M9014 gateway provides a cable management bracket at the chassis bottom to route
power cords. The procedure for removing the cable management bracket on an M9006, M9014, and
M9010 are the same.
This section takes removing a cable management bracket from an M9010 gateway as an example.
To remove the cable management brackets:
1.
Prepare the packing bag of the cable management brackets. Make sure the bag is clean, dry,
and not damaged.
2.
Use a Phillips screwdriver to loosen the screws that attach the cable management brackets to
the chassis, and then remove the cable management brackets.
3.
Put the cable management brackets into the bag.
