35
6.
Put the removed power module on the antistatic mat.
7.
Install a new power module. For the installation procedures, see "Installing a power module."
If no new power module is to be installed, install a blank filler panel to ensure adequate
ventilation and dust prevention.
Figure 33 Removing the vertically-oriented AC power module (M9010, M9010-GM, and
M9014)
Figure 34 Removing the horizontally-oriented AC power module (M9006)
Replacing a card
The cards on the M9000 gateways can be installed in horizontal or vertical slots, and the
replacement procedures are the same. The following takes a card installed in a horizontal slot as an
example.
To replace a card:
1.
Prepare an antistatic mat to place the removed card.
2.
If the card is an MPU, interface module, or service module, remove all its cables.
3.
Use a Phillips screwdriver to remove the captive screw on the card, as shown in callout 1
on
4.
Move the ejector levers outwards to separate the card from the backplane, as shown in callout
2 on
.
