4-30
4.
Install a new drive. For the installation procedure, see "
Figure4-3 Removing a drive
Replacing a transceiver module
WARNING!
Disconnected optical fibers or transceiver modules might emit invisible laser light. Do not stare into
beams or view directly with optical instruments when the firewall is operating.
When you replace a transceiver module, make sure the two transceiver modules connected by the
same optical fiber are the same type. Do not touch the golden plating of the transceiver module.
Figure4-4 Transceiver module golden plating
To replace a transceiver module:
1.
Use the
shutdown
command in interface view at the CLI to shut down the optical source
before you remove the fiber connector.
2.
Remove the LC connectors with the optical fiber from the transceiver module, and install dust
caps to the LC connectors.
3.
Pivot the clasp of the transceiver module down to the horizontal position, and gently pull the
transceiver module out.
Figure4-5 Removing the transceiver module
4.
Install dust caps to the removed transceiver module, and put it into the package.
5.
Install a new transceiver module. If you do not install a new transceiver module in the slot, install
a dust cap. For information about installing a transceiver module, see "
1
2
3
Golden
plating
1
2
Summary of Contents for SecPath F100-X-G3
Page 63: ...i Contents 1 Appendix B LEDs 1...
