Operation Manual – RPR
H3C S9500 Series Routing Switches
Chapter 1 RPR Configuration
1-21
000f-e257-0002 1 1
--- Total entries: 1 ---
# Display the information of the overall ring selection table to verify the configuration.
[Sysname-Ten-GigabitEthernet1/1/1] display rpr rs-table overall
Overall ringlet selection table of interface: Ten-GigabitEthernet1/1/1
MAC-Address Ringlet TTL Type IP-Address Station-Name
000f-e257-0002 1 4 static 0.0.0.0
000f-e257-0003 0 2 dynamic 0.0.0.0
000f-e257-0004 1 2 dynamic 0.0.0.0
000f-e257-0005 1 1 dynamic 0.0.0.0
--- Total entries: 4 ---
1.16.2 RPR VLAN Tunnel Configuration Examples
I. Network requirements
On an RPR network, station A uses interface Ten-GigabitEthernet1/1/1 as its RPR
logical port; station D uses MAC address 000F-E200-8582.
Configure an RPR VLAN tunnel on station A to tunnel VLAN 10 streams to station D.
II. Network diagram
Figure 1-9
Network diagram for RPR VLAN tunnel configuration
III. Configuration procedure
On station A:
# Enter system view.
<Sysname> system-view
# Enter RPR logical interface view.
[Sysname] interface ten-gigabitEthernet 1/1/1
# Configure the link type of the interface as trunk.