Operation Manual – GVRP
H3C S9500 Series Routing Switches
Chapter 1 GVRP Configuration
1-7
1.3 Displaying and Maintaining GVRP
To do…
Use the command…
Remarks
Display statistics about
GARP
display garp statistics
[
interface
interface-list
]
Available in any view
Display GARP timers for
specified or all ports
display garp timer
[
interface interface-list
]
Available in any view
Display statistics about
GVRP
display gvrp statistics
[
interface
interface-list
]
Available in any view
Display the global GVRP
state
display gvrp status
Available in any view
Clear the GARP statistics
reset garp statistics
[
interface interface-list
]
Available in user view
1.4 GVRP Configuration Example
1.4.1 GVRP Configuration Example I
I. Network requirements
Configure GVRP for dynamic VLAN information registration and update between the
switches. The trunk ports are in the default “normal” registration mode.
II. Network diagram
Figure 1-2
Network diagram for GVRP configuration
III. Configuration procedure
1)
Configure Switch A
# Enable GVRP globally.
<SysnameA> system-view
[SysnameA] gvrp
# Configure port Ethernet 1/1/1 as a trunk port, allowing all VLANs to pass.
[SysnameA] interface ethernet 1/1/1
[SysnameA-Ethernet1/1/1] port link-type trunk
[SysnameA-Ethernet1/1/1] port trunk permit vlan all
# Enable GVRP on Ethernet 1/1/1, the trunk port.