3-5
Figure 3-8
Attach the 1U mounting bracket to an S5820X-28S for rear mounting
Note that each of the above figures shows only how to install one 1U bracket, because the installation
procedures of the two brackets are the same.
Figure 3-9
Attach the 2U cable management bracket and mounting bracket kit to an S5820X-28C
Note that if the 2U cable management bracket and mounting bracket kit is used for a center mounting of
S5820X-28C, you need to separate the mounting bracket and cable management bracket (they are
fixed by default; to separate them, use a screwdriver to loosen the three captive screws, as shown in
Figure 3-10
). Then follow the steps above to attach the mounting brackets to the switch.
Figure 3-10
Separate the cable management bracket and mounting bracket
(2)
(1)
(3)
(1)
Separate the mounting
bracket and cable
management bracket
(1) Captive screws
(2) Cable management bracket
(3) Mounting bracket
Mounting the Switch to a Rack
Before installation, make sure that:
Step1
Wear an ESD-preventive wrist strap and make sure the rack is well grounded and is firm enough to hold
the switch and cables.
Summary of Contents for S5820X-28C
Page 84: ...6 6 z Emulation VT100 ...
