8
Rack-mounting the switch by using front mounting brackets
(for the S5560X-30C-EI, S5560X-54C-EI, S5560X-30F-EI,
S5560X-54F-EI, S5560X-34S-EI, and S5560X-54S-EI
switches)
Attaching the front mounting brackets to the switch
1.
Determine the mounting position for the front mounting brackets.
You can install the front mounting brackets at the port side or power module side.
2.
Attach the front mounting brackets to the chassis:
a.
Align the round holes in the wide flange of one front mounting bracket with the screw holes
in the chassis. See
and
b.
Use M4 screws (provided with the switch) to attach the mounting bracket to the chassis.
c.
Repeat the proceeding two steps to attach the other mounting bracket to the chassis.
Figure 6 Attaching the front mounting bracket to the port side
Figure 7 Attaching the front mounting bracket to the power module side
Mounting the switch in the rack
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Make sure the front mounting brackets have been attached securely to the two sides of the
switch.
3.
Install cage nuts (user-supplied) in the mounting holes in the rack posts. Make sure the
corresponding cage nuts on the left and right front rack posts are at the same height.
