2-19
z
If you change the type of RADIUS server, the data stream destined to the original RADIUS server
will be restored to the default unit.
z
When the third party RADIUS server is used, you can select standard or extended as the
server-type in a RADIUS scheme; when the CAMS server is used, you can select extended as the
server-type in a RADIUS scheme.
Configuring the Status of RADIUS Servers
For the primary and secondary servers (authentication/authorization servers, or accounting servers) in
a RADIUS scheme:
When the switch fails to communicate with the primary server due to some server trouble, the switch will
turn to the secondary server and exchange messages with the secondary server.
After the primary server remains in the
block
state for a set time (set by the
timer quiet
command), the
switch will try to communicate with the primary server again when it receives a RADIUS request. If it
finds that the primary server has recovered, the switch immediately restores the communication with
the primary server instead of communicating with the secondary server, and at the same time restores
the status of the primary server to
active
while keeping the status of the secondary server unchanged.
When both the primary and secondary servers are in
active
or
block
state, the switch sends messages
only to the primary server.
Table 2-18
Set the status of RADIUS servers
Operation
Command
Remarks
Enter system view
system-view
—
Create a RADIUS scheme and
enter its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS scheme
named "system" has already
been created in the system.
Set the status of the primary
RADIUS
authentication/authorization
server
state
primary
authentication
{
block
|
active
}
Set the status of the primary
RADIUS accounting server
state
primary
accounting
{
block
|
active
}
Set the status of the secondary
RADIUS
authentication/authorization
server
state
secondary
authentication
{
ip-address
|
ipv6
ipv6-address
} {
block
|
active
}
Set the status of the secondary
RADIUS accounting server
state
secondary accounting
{
ip-address
|
ipv6
ipv6-address
} {
block
|
active
}
Optional
By default, the RADIUS servers
specified with IP addresses in
the RADIUS scheme are all in
the
active
state.
Summary of Contents for S3100 Series
