10
Installation
Precautions
To avoid any device impairment and bodily injury caused by improper
use, observe these rules:
•
Do not place the RPS1600-A on an unstable case or table, and
ensure that the cabinet and the workbench are firm enough to
support the RPS1600-A and its accessories.
•
Make sure that the cabinet and workbench has a good
ventilation system, and enough room is left around the air intake
and outlet of the RPS1600-A for heat dissipation. Never block
the air intake and outlet of the RPS1600-A. (The air intake of the
RPS1600-A is located on the front panel of the AD162M56-1M1/
AD162M56-1M1A. Air flows in through the air intake and flows
out through the heat dissipation holes located at the two sides of
the RPS1600-A.)
•
Keep the RPS1600-A away from high-power radio transmitters,
radars, and high-frequency devices working in high current. Use
electromagnetic shielding when necessary.
•
Make sure that the operating voltage of the power source
matches the voltage required by the RPS1600-A.
•
Interface cables must be routed indoors. Otherwise,
over-voltage and over-current may damage the device. As for
power cables from the outside of the building, you can add a
dedicated lightning arrester at the input end of the cables.
•
To enhance lightning protection, add a power lightning arrester
at the input end.
•
Wear an ESD-preventive wrist strap when installing the
RPS1600-A, and make sure that the wrist strap has good skin
contact.
