5-13
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
===========================================================================
Enter your choice(0-4):
5) Select
0
in the BootWare operation Ethernet interface submenu to return to the BootWare
operation submenu:
=========================<BootWare Operation Menu>=========================
|Note:the operating device is cfa0 |
|<1> Backup Full BootWare |
|<2> Restore Full BootWare |
|<3> Update BootWare By Serial |
|<4> Update BootWare By Ethernet |
|<0> Exit To Main Menu |
===========================================================================
Enter your choice(0-4):
6) Select
0
in the BootWare operation submenu to return to the BootWare main menu:
===========================<EXTEND-BOOTWARE MENU>==========================
|<1> Boot System |
|<2> Enter Serial SubMenu |
|<3> Enter Ethernet SubMenu |
|<4> File Control |
|<5> Modify BootWare Password |
|<6> Skip Current System Configuration |
|<7> BootWare Operation Menu |
|<8> Clear Super Password |
|<9> Storage Device Operation |
|<0> Reboot |
===========================================================================
Enter your choice(0-9): 0
7) Select
0
in the BootWare main menu to reboot the LSQM1WCMB0 access controller module.
Upgrading Applications
The same procedure is used to upgrade the three types of application files. This section describes how
to upgrade the main application file.
Upgrading Applications Through a Serial Connection
Follow these steps to upgrade the main application file through a serial connection:
1) Use the serial interface submenu to update application files. Select
2
in the BootWare main menu
to enter the serial interface submenu. For details about this menu, refer to section “Serial interface
submenu” on page 5-5.
2) To improve the upgrade speed, first modify the serial interface baud rate. For details, refer to
section “Modifying serial communication parameters” on page 5-7.
3) Select
2
in the serial interface submenu. The following prompt appears:
Please Start To Transfer File, Press <Ctrl+C> To Exit.
