H3 Falcon 4210, Quick Installation Manual

Page: 12 / 24

9
4 port x4 lanes (Advanced mode)
Connect the correspond ports as shown in the right diagram.
After booting up Falcon 4210,
Go to GUI
→
Port Configuration
Set the host port to 4x4 mode before power on the host machines.
Host 1 will be recognized as 1:H1.0
Host 2 will be recognized as 1:H1.1
Host 3 will be recognized as 1:H1.2
Host 4 will be recognized as 1:H1.3
If your HBA (host side) is installed in different directions, make sure you connect the
cables to the right connectors.
Failure to follow the cabling order may result in system error.
Host 1 - Chassis
0 - 0
Host 2 - Chassis
0 - 1
Host 3 - Chassis
0 - 2
Host 4 - Chassis
0 - 3