4
of equal thickness behind it when feeding through the planer. Be sure the last board of a butted
sequence is 250mm long or longer.
24. Wear ear protectors (plug or muffs) during extended periods of operation. If the board being
planned stops feeding, disengage or turn the feed off and turn the power off. Wait until the cutter head
comes to
a complete stop before lowering the table to remove the board. Never lower the table with the power
on and the stock still in the machine. A kickback can occur which could cause severe or fatal injury.
25. If the operator leaves the machine area for any reason, the planer should be turned “OFF” and the
cutter head should come to a complete stop before leaving the machine. In addition, If the operation is
complete, the operator should clean the planer and the work area.
26. Turn off the machine before cleaning, Use a brush or compressed air to remove chips or debris—do
not use your hands.
27. Do not stand on the machine. Serious injury could occur if the machine tips over.
28. Maintain a balanced stance at all times so that you do not fall or lean against the knives or other
moving parts. Do not overreach or use excessive force to perform any machine operation.
29. Use recommended accessories, Improper accessories may be hazardous.
30. Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for
which it was not designed. The right tool will do the job better and safer.
31. Only cutter compliance with EN847-1 can be used in this machine.
32. Do not use this planer for other than its intended use. If use for other purposes, disclaims any real or
implied warranty and holds itself harmless from any injury that may result from that use. .
33. This planer is designed and intended for use by properly trained and experienced only. If you are not
familiar with the proper and safe operation of a planer, do not use until proper training and knowledge
have been obtained.
34. Replace the warming labels if they become obscured or removed.
35. Provide for adequate space surrounding work area and non-glare, overhead lighting.
36. Do not operate this machine while tired or under the influence of drugs, alcohol or any medication.
Using restriction
The machine is designed for woodworking purpose (e.g. wood, plywood, composite
wood, etc.).
It is prohibited to process any other materials of work piece, (e.g. metal material,
rubber/plastic material, alloy. Etc.).
