16
Lubrication Point
Frequency type
Cutterhead Housing
Weekly
High Speed grease
Table
Daily
SAE10
The lead screws
Weekly
SAE10
The lead screws housing
Monthly
High Speed grease
The columns housing Monthly
High Speed grease
Changing Fuses
Disconnect planer from power source, and open the
electrical enclosure. Pull open the cover on a fuse
holder. As shown in figure10 and slide out the old
fuse. Replace it with a new one of the proper
amperage. Close the cover.
Figure 10
Do not use a fuse with amperage
ration different than what is listed
on the cover of the fuse holder
Before and intervention on the
machine, disconnect it from the
electrical supply by pulling out the
plug or switching off the main
switch! Follow lockout procedures.
Failure
to
comply
may cause
serious injury.
Maintenance
Before and intervention on the
machine, disconnect it from the
electrical supply by pulling out the
plug or switching off the main
switch! Follow lock out / tag out
procedures.
Failure
to
comply
may cause serious injury.
1.
The anti-kickback fingers must hang down freely
and operate independently by gravity. They
should be inspected frequently and cleaned and
concerning state of the tip and any destruction
whenever
necessary.
If
they
have
any
destruction, shall be order our agent for new
anti-kickback fingers.
2.
The table should be kept clean and free of rust
or deposits.
3.
The lead screws and posts beneath the table
and the drive chains, the columns should be kept
clean and oiled
4.
Periodically blow out sawdust from the motor’s
cooling fan.
5.
Periodically check the brake of motor, Change
new brake block then thickness of brake block is
less 3mm.
6.
The infeed roller and outfeed roller are mounted
on sealed ball bearing and require no lubrication.
The following lubrication chart indicates the
lubrication points, frequency, and recommended
lubrication.
