6
Slump the wire in the moto wire feeder entrance. Release the clamping at maximum. Close the plate of the moto wire feeder.
Press on the gate and tighten little by little the clamping handle until the motor start to drive the wire.
.
5-7) Brake adjustment from the coil support
You must block this one in function of the weight coil used.
Too blocked: the motor is in difficulty and the thread risk not to drive.
Release: the important coil inertia can drive the wire rolling after end welding.
VI / USING IN ALUMINIUM
The setting of the torch for Aluminium is fundamental.
The essential precautions are the following:
- Don’t use the brass capillary tube in the euro adapter, but use the
Teflon envelope, which must come until the moto-wire feeder
roller.
- In ALUMINIUM, use a contact tube of a diameter immediately
superior to the section of the wire used.
- Use ALU rollers identical with wire diameter.
VII / OPTION FOR MAGYS 263 et 261
MAGYS 263 and 261 machines are evolutives terminals. For origin machine, we can uniquely use this one with the
moto wire feeder. Then, we can advanced the product with separated wire feeder with equipping it with a WF wire
feeder and a contact batch from 5 or 10 meters.
When the machine is totally equipped, the choice of the moto wire feeder will be in function of the commutator position
in foreside.
1
4
3
2
Origin moto-wire feeder on
the generator
Option wire feeder WF
