The manufacturer does not accept any liability in relation to damages caused to objects or harm caused to persons
as the result of incorrect and/or dangerous use of the machine .
MAINTENANCE / RECOMMENDATIONS
• The operators must have received suitable training in order to use the machine at its maximum potential and
weld correctly.
• Check which welding process is authorised by the manufacturer before attempting any vehicle repair.
• The maintenance and the repair of the . Any work undertaken by a third party on the generator will invalidate the warranty. The
manufacturer will not accept liability in the event of an incident that would occur after this work was undertaken.
• Ensure the machine is unplugged from the mains, and wait for two minutes before carrying out maintenance work. Inside, voltages
and currents are high and dangerous.
• All the welding tools will wear off with use. Ensure that these tools are clean to get the best results.
• Prior to using the gun, check the condition of the different tools (star, single sided electrode, carbon electrode...) and clean or
replace if required.
• Remove regularly the casing and any excess of dust. Take this opportunity to have the electrical connections checked by a qualified
person, with an insulated tool.
• Regularly review the condition of the power cable and welding connection cables. In case of visible signs of damage, organise for
them to be replaced by the manufacturer or a qualified technician.
• Ensure the vents of the device are not blocked to allow adequate air circulation.
INSTALLATION – PRODUCT OPERATION
GENERAL DESCRIPTION
This product has been designed to carry out the following operations in a car body workshop: Dent pulling; welding of nails,
rivets, rings and pins; removal of bumps and dents; sheet stretching. It is not designed for the assembly of metal parts. This
device is delivered with an earth clamp, a gun (with cable), a consumables and accessories box, and an SOOW mains cable.
Accessories
2600
2700
34.02
34.04
39.02
39.04
PRO 230
PRO 400
Earth plate
Separate gun lead
Automatic Quick Gun
Manual Quick Gun
Spotter Box
Spotter Box Pro
PRODUCT SPECIFICATIONS
2600
2700
34.02
34.04
39.02
39.04
PRO 230 PRO 400
ELECTRIC SPECIFICATIONS
U
1N
rated power supply voltage
1 ~ 230 V
2 ~ 400 V
1 ~ 230 V
2 ~ 400 V
1 ~ 230 V
2 ~ 400 V
Frequency
50/60 Hz
U
20
rated no load voltage
5.5 V
7.6 V
7.8 V
De 0.5 à 7.4 V
Permanent power U
SP
1 kVA
1.8 kVA
2.0 kVA
1.8 kVA
Permanent supply current I
1p
4.7 A
6.9 A
5.3 A
9 A
5 A
9 A
5 A
Maximal current of a permanent primary
short circuit I
1cc
43 A
80 A
51 A
90 A
52 A
90 A
52 A
Maximal current of a secondary short cir-
cuit I
2cc
1800 A
2400 A
2600 A
2800 A
Permanent secondary current I
2p
160 A
240 A
270 A
270 A
Type of welding current
13
GYSPOT 2600 / 2700 / 34.02 / 34.04 / 39.02 / 39.04 / PRO 230 / PRO 400
EN
Translation of the original instructions
