20
GYSDUCTION AUTO
EN
Translation of the original instructions
Bolt inductor
ref. 053366
Description
The bold inductor is used for intense heating of rusted or seized parts such as nuts and bolts. This inductor can also be
used for removing caulking from truck chassis or car trunks, for welding large connectors or for metal forming.
Use
•
To remove a seized or rusted nut / bolt:
1.
Choose Auto mode or set the power at a very high level (80 to 100% of power).
2.
Place the bolt inductor on the nut as shown.
3.
Start the heater and let it run for a few seconds.
4.
Loosen the nut or the bolt.
Adhesive inductor
ref. 053359
Description
This inductor is designed to peel off door mouldings / rubbing strips, badges as well as advertising and decorative
adhesives in a few minutes without damage.
Use
•
For heating painted metal sheets
1.
Select Auto mode or set the power to a low level (10 to 30% of its maximum heating capacity).
2.
Place the inductor just above the area to be heated. There must be no contact between the inductor and the area
or element to be heated.
3.
While activating the heater, make a circular or to-and-fro movement on the area to be heated.
If the inductor stays too long on the same area, the paint may burn. To avoid this, it is necessary to keep the inductor
constantly in motion (back and forth or circular).
•
For peeling off decals, vinyl stickers or glued bars
Carry out the three steps described above (see to heat the pain
-
ted sheets). Heat for a few seconds and try to lift one edge of
the element. If it starts to peel off easily upwards, the required
temperature has been reached, otherwise continue heating for
a few more seconds and try again.
