COMPONENT SPEAKER SYSTEMS
CS-CM50
CS-CM60
Peak Power (Watts)
220
240
Rated Power (Watts)
35
40
Frequency Response
41Hz - 26kHz
35Hz -26kHz
Impedance
4 Ohms
4 Ohms
Sensitivity
85dB
86dB
Cone Material
Polypropylene
Polypropylene
Tweeter
PEI
PEI
Mounting Depth
43mm (1-11/16”) 45.5mm (1-13/16”)
Mounting Diameter
118mm
126mm
(4-21/32”)
(5”)
CS-CM50
CS-CM60
WARNING:
Do not drill mounting holes with speaker in place as this could allow drill shavings to damage the
voice coil and void your warranty.
SPEAKER PARAMETERS
www.fusionelectronics.com
TWEETER
Ø 53mm
(2-1/16”)
9mm (11/32”)
20mm (25/32”)
47mm
(1-27/32”)
INSTALLATION GUIDELINES
Ensure the audio system is turned off before making any connections
to the amplifier, speakers or source unit. Failure to do so could result in
permanent damage to the audio system.
When wiring the speakers ensure that the wire is protected from sharp
objects and always use rubber grommets when wiring through metal
panels. Ensure all terminals and connections are protected from the
vehicle chassis and from each other as failure to do so could result in
permanent damage to the audio system.
When connecting the source unit and speakers ensure you connect
the positive and negative output wire from the source unit to the
corresponding speaker terminals. This will ensure the audio system will
be in phase.
1) Ensure there is adequate clearance & depth for the speaker to be
mounted
2) Use the supplied template to mark out & cut the correct diameter hole
3) Drill four holes for the mounting screws
4) Seperate the grille from the frame
5) Insert the speaker & grille frame and affix with the screws provided
6) Complete installion by replacing the grille into the grille frame
