EN
13
Operating manual
SMART HUB MODULE
Translation of the original
instructions
1
Uncap the GYSFLASH CNT.
Unplug your GYSFLASH at least 10 minutes before disassembly. This operation should only be carried
out by a qualified person
2
Locate the micro-switches that allow you to change the Mas
-
ter/Slave positi
on of t
he
charger.
When it leaves the factory, the GYSFLASH is always in the
Master
position.
Depending on the desired configuration, set the position of the
GYSFLASH as shown below:
Master
Slave 1
Slave 2
Slave 3
Each GYSFLASH in parallel must be in a different position.
It’s not possible to have tw
o Mast
er products or t
wo of Slave 1 for example.
3
Recap the GYSFLASH CNT.
4
Switch on the Master Charger and perform the following operation to activate the “Multi-Charger” mode:
-
Press the MODE button for 3 seconds to access the “Config
-
uration” Menu
-
Use the arrow keys to navigate to “Multi-Charge
r mode”.
Multi-charger Mode
CONFIGURATION
-
Press Select to enter the mode.
Multi-Charger mode
OFF
-
Press Select again to activate the mode and use the arrows
to select the configuration that suits your installation: «
MAS-
TER + 1 SLAVE
» — «
2 SLAVE
» — «
MASTER
+ 3 SLAVE
».
X SLAVE
Multi-Charger mode
Summary of Contents for 025981
Page 31: ...RU 31 SMART HUB MODULE 50 C EAC C...
Page 37: ...RU 37 SMART HUB MODULE 2...
Page 55: ......
