12
Operating manual
SMART HUB MODULE
Translation of the original
instructions
CONNECTION OF SEVERAL MODULES
For the SHM device to work, a GYSFLASH CNT charger must be connected to channel 1 (FIG II) via the
SMC cable supplied.
Using the power cord
•
If there are as many chargers as there are modules connected to the SHM, the presence of the mains is not mandatory.
Each GYSFLASH provides the necessary energy to the module connected to its channel.
To benefit from the energy supplied by the charger, a module must be connected to the same channel as
a GYSFLASH.
•
In general, connecting the SHM to the mains opens up all the channels without having to resort to the number of GYS
-
FLASH needed to power all the modules. It should be used when more modules than chargers are to be connected to
the SHM.
Need to use the power cord
Number of connected modules
1
2
3
4
Number of
connected
GYSFLASH
1
No
Yes
Yes
Yes
2
No
No
Yes
Yes
3
No
No
No
Yes
4
No
No
No
No
Example:
A module can be connected to channel 3 (LED on) when:
- a GYSFLASH is connected to channel 3.
- the power cord is plugged in and a GYSFLASH is present on
channel 1.
Connecting a GYSFLASH with several modules:
1
Connect the GYSFLASH to channel 1 via the SMC lead supplied with the SHM.
2
Connect the modules (SMC cable supplied with the modules).
3
Connect the mains plug.
4
Connect the charger to the battery (refer to the GYSFLASH manual).
5
Switch on the charger.
PARALLELING GYSFLASH CNT
Paralleling can only be done with identical GYSFLASH CNT (maximum 4).
Master/Sl
ave communication:
Parallel connection of GYSFLASH CNT chargers is done via a Master/Slave configuration.
One GYSFLASH (th
e Mast
er) controls all the others (the
Secondaries).
Setting the GYSFLASH as Mas
ter or
Slave
requires a manipulation on each of them.
Summary of Contents for 025981
Page 31: ...RU 31 SMART HUB MODULE 50 C EAC C...
Page 37: ...RU 37 SMART HUB MODULE 2...
Page 55: ......
