PLASMA
ARC45
Gouging/cutting mode
, use the encoder to adjust the
cutting current, press on the function button briefly
to switch operational mode.
The current range is 10-45A. When the current is
between 20A and 45A, the cutting mode is gouging,
the recommended value is 3.5Bar.
When the current is between 10A and 20A, the
cutting mode is marking, the recommended value is
2.4Bar.
4.2 Cutting parameters
(which contains air pressure/output voltage/the
recommended length of the cutting torch)
Holding down the function button for 1 second will
flash the cutting parameters and allow you to change
the barometric millimeter of mercury.
Press on the function button briefly to set Bar, Mpa or
Psi. When the air is released, the LCD will display real
time pressure, otherwise it displays the recommended
air pressure.
Continuing to press on the function button briefly will
display output voltage and the recommended length
of the cutting torch. As shown in the following
Figures.
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
8
