7
4. Function introduction
PLASMA
ARC45
8
1 2 3
6
4
5
9
10
7
1.
Check whether the cutting torch is connected
2.
Gas/air pressure light
3.
The machine is in working condition
4.
Grid Cutting Mode
5.
Normal cutting mode
6.
Gouging/cutting mode
7.
The types of the cutting torch
8.
Transfer arc player
9.
Cutting parameters which contains air pressure
/output voltage/ the recommended length
of the cutting torch
10.
Cutting current
4.1 Cutting mode selection
Grid cutting mode
, use the encoder to adjust the
cutting current, press on the function button briefly
to switch cutting mode.
The current range is 20-45A, the recommended value
is 4.8Bar.
Tips:
The LCD contains two menus.
In the first menu, the cutting current and the cutting
mode can be adjusted.
Holding down the function button for 1 second will
flash the cutting parameters and change to the
second menu.
If there is no operation for 6 seconds, hold down the
function button for 1 second again and the cutting
current display will flash and switch back to the first
menu.
Normal cutting mode
, use the encoder to adjust the
cutting current, press on the function button briefly
to switch cutting mode.
The current range is 20-45A, the recommended value
is 4.8Bar.
