════════════════════════════════════════════════
7
Chapter 3. TOUCH SCREEN CONTROLLER HARDWARE INSTALLATION
5 Wires Resistive USB Touch Screen Controller Hardware Installation
This chapter discusses how to install your 5 wires resistive serial touch screen controller, follow the directions
starting on the next section to install the controller to your computer.
IMPORTANT:
Before connecting the touch screen controller to your computer system,
Be sure that the computer system is turned off.
1. Turning Off Your Computer System
Before you install the 5 wires resistive USB touch screen controller, turn off your computer system.
2. Connecting the Controller
The 5 wires resistive USB touch screen controller included a USB cable, which has 5-pin D connector.. Plug the
USB cable into a USB port on your computer directly .
3. Supplying Power to the Controller
The 5 wires resistive USB touch screen controller included a 5-pin USB cable, which using to provide power to
the controller.
To connect USB cable:
• Plug the USB cable into usb port.
4. Mounting the Touch Panel
There are several methods for mounting the touch panel (or sensor) depending on your application. The 5 wires
resistive serial touch screen controller included a 5-pin ( pitch 2.54mm) touch panel cable. The Pin Assignment of
Touch Panel Cable listed in below, if your touch panel’s pin out does not match it, you may need jumping cable
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
RT RL SG LT LL
