-
The hob must be installed in such a way as to ensure the best possible heat radiation,
which increases the efficiency of the appliance.
The wall trim and work surface next to the hob must be heat-resistant.
Multilayer boards and adhesives must be heat-resistant to prevent damage.
The use of steam cleaners is not recommended.
This device may only be connected to a system with a resistance not exceeding
0.427 ohms. If necessary, contact your energy supplier for system resistance.
-
-
-
-
Connecting the appliance to the mains
The power supply must be connected in accordance with the applicable standard or using a
single-pole switch. The connection method is given below.
-
If the supply cord is damaged or needs to be replaced to avoid an
accident, the after-sales service must be carried out by a specialist.
-
-
If the appliance is connected directly to the power supply, the circuit breaker
must have a gap of at least 3 mm between the contacts. The installer must
ensure a suitable electrical connection that meets safety requirements.
The power cord must not be bent or compressed.
The power cord should be inspected and replaced regularly by a qualified
technician.
-
-
26