Gunnebo RotaSec B120D, Installation, Operation And Maintenance Manual

Page: 78 / 100

78
.............................
CCEC/ OM Manual RotaSec Titan 1.5 EN 08.2009
Card Reader Mounting
Refer to Gunnebo Technical department for information and recommendations.
Customer Connections
On completion of the installation routines the RotaSec
System must be connected to the Customer‟s
services.
Electrical Connections
Note
–
The following routines must be carried out by a qualified electrician .
Fig 5.26 Mains Power Electrical Power Preparation

Check the incoming mains supply is isolated.

Feed the mains supply cable through the RotaSec towards the MCB.

Cut back and strip the sleeving as shown in Fig. 5.26

Remove the terminal cover from the MCB.

Clamp the cable using a cable tie through the base of the MCB mounting block.

Connect the wires as shown in Fig. 5.26

Replace the terminal cover.
To turnstile PSU by
Gunnebo Entrance Control Incoming mains and connection
by customer
Incoming Cable
Brown
(L) to terminal 2
Blue (N) to terminal N
Green/Yellow (E) to earth stud
Connect to earth stud
on mounting channel