Gunnebo RotaSec B120D, Installation, Operation And Maintenance Manual

Page: 30 / 100

30
.............................
CCEC/ OM Manual RotaSec Titan 1.5 EN 08.2009
Changes to the Programmable Parameters
The installation/service/maintenance engineer can perform changes to the parameters or carry out
input and output tests using a sub system of the LCM02 PCB consisting of two seven segment
displays (T1 and T2) and pushbuttons SW1, SW2, SW3 and SW4.
Figure 4.13 Programming Pushbutton and Switch Locations
Standard Jumper Settings
JP 5,7,10,12 2-3
JP13 OFF
JP14 OFF
JP15 OFF
JP18 ON
JP19 ON
JP20 OFF
Qualified personnel only must carry out parameter changes .
It is recommended that before any changes are made the old locations and values are recorded, and
when the change is completed the new values are listed for record purposes.