Gunnebo RotaSec B120D, Installation, Operation And Maintenance Manual

Page: 31 / 100

31
.............................
CCEC/ OM Manual RotaSec Titan 1.5 EN 08.2009
Accessing the Parameter Change Mode
To access the parameter change mode:
1. Press and hold down pushbutton SW2
2. Reset the microprocessor by pressing and releasing SW1
3. Release SW2
A number will be shown on the Display.
If the number has two decimal points - it is the LOCATION.
Location
If not - it is the PARAMETER VALUE .
Value
Pressing pushbutton
SW2 will cause the logic to switch between PARAMETER LOCATION and
RELATIVE VALUE.
SW2
↔
Location Value
Pressing
SW3 when a Location is displayed will move to a lower location.
SW3
→
Location Location
Pressing
SW3 when a Value is displayed will decrease the VALUE.
SW3
→
Value Value
Pressing
SW4 when a Location is displayed will move to the next higher Location.
SW3
→
Location Location
Pressing
SW4 when a Value is displayed will increase the Value.
SW4
→
Value Value
When all required adjustments have been made
– start the program using the RESET pushbutton
SW1 .
Note
– Should the LCM02 display go blank when pressing
SW1 , turn the power off and then
back on. (Hard reset)