9
9
Installation instructions and placement of the GOBOOSTER child
car seat in a vehicle
The improper placement of the child car seat in the vehicle increases the risk of injury of a
transported child. Some older cars are not accommodated for the child car seat application,
they are not equipped with the approved three-point adult safety belts. The three-point adult
safety belt is provided with the homologation label which among others includes the
homologation mark qualifying the safety belt. The homologation mark starts with the letter
A. The examples of homologation marks are A, Ar4m. If you are not sure of possibility
whether the GOBOOSTER child restraint system can be used in your vehicle, consult the
instructions for use.
The central rear seat at older cars is equipped generally with a two-point safety belt which
leads across the lap only. The child car seat must not be applied on this seat.
The child car seat must always be placed facing forward in the travel direction.
10
Basic adjustment of the GOBOOSTER child car seat for a
transported child
The seating of a child in the GOBOOSTER child car seat is illustrated in Figure 3.
Place the inflated child car seat on
the left or right seat
of a vehicle.
On the child car seat, check the position of the upper belt holder whether it is located on the
correct side according to the left or right position of the child car seat in the vehicle.
If the holder position is the opposite side than we need, re-mount it as follows:
-
Unbuckle the metal tintack on the rear holder side (see Figure 3, detail C
1
); remove it
from slots forward and remove it to the correct side with the reversed procedure;
-
Seat the transported child in the child car seat
Carry out the basic adjustment in such a way that you choose the proper setting of the upper
belt holder:
-
Unbuckle the buckle (trident) of belt holder (see Figure 4, detail C
2
));
-
Fasten the transported child with the vehicle fastening strap in the child car seat
-
Adjust and tighten the belt leading above the chest so that the belt may not threaten the
neck, and so that it may not slip over the shoulder down;
-
Adapt the adjustment of the upper belt holder to this belt position.
Eight slots in the child car seat edge allow in total five settings of the holder which always
occupies the length over four slots.
