13
When using a contra-angle handpiece with a gear ratio of 16:1,
touch the 16:1 speed ratio button.
When using a contra-angle handpiece with a gear ratio of 1:1, touch
the 1:1 speed ratio button.
When using a contra-angle handpiece with a gear ratio of 1:5, touch
the 1:5 speed ratio button.
5.6.2 LED: Turn on/off the LED light on the motor by touching the
LED key.
5.6.3 Speed adjustment: Adjust the speed of the motor by touching
the Speed adjustment key.
5.6.4 Forward/reverse rotation: Switch to the forward rotation or
reverse rotation by touching the Forward/reverse rotation key.
5.6.5 Mode: Select the working speed of corresponding mode by
touching the Mode key.
5.6.6 Store: Store the set speed ratio, speed, mode, forward rotation/
reverse rotation, and LED by touching the Store key.
5.6.7 Setting: Enter setting interface by touching the Setting key.
5.7 Basic funtion adjustment in setting interface
5.7.1 In setting interface, touch key “8” Manual Mode key to enter
manual mode interface. Under the manual mode state, the rotation
of motor can be directly controlled without foot pedal. Touch Speed
Ratio key to select corresponding speed ratio. Touch Speed key to
adjust the speed. Touch Start key, Stop key, Forward/Reverse
Rotation key, or LED key to control the output of motor. Touch the
Exit key to exit the manual mode interface.
5.7.2 In setting interface, touch key “9” Calibration key, touch Start
key, and the interface shown in Figure 8,9 would pop up. Fully press
down the foot pedal until 100% is displayed, then release the foot
pedal to finish the calibration.
5.7.3 In setting interface, touch key “10” Restore Factory Setting
key, click “OK” to enter interface shown in Figure 10, and decide
whether to restore the factory setting by clicking “OK” or “Cancel”
key.
5.7.4 In setting interface, touch key “11” to enter interface shown in
Figure 7 for language selection.
5.7.5 In the setting interface, touch key “12” to exit sub-menu
setting mode.