WARRANTY AND SERVICE
CERTIFICATION:
Guildline Instruments Limited certifies that this product was tested
and inspected and found to meet its published specifications when it was shipped from
the factory.
WARRANTY:
This product is warranted against defects in materials and workmanship
for a period of two years from date of shipment. During the warranty period, Guildline
Instruments Limited will, at its option, either repair or replace products that prove to be
defective.
SERVICE:
For warranty service or repair, this product must be returned to the factory.
The buyer shall prepay shipping charges to Guildline Instruments Limited and Guildline
Instruments Limited shall pay surface shipping to the buyer. Permission must be
obtained from the factory for warranty repair returns.
LIMITATIONS:
The foregoing warranty shall not apply to defects resulting from
improper or inadequate maintenance by the buyer, or unauthorized modifications or
misuse.
Neither Guildline Instruments Limited nor any of its employees shall be liable for any
direct or indirect, special, incidental or consequential damages arising out of the use of
this product.
No other warranty is expressed or implied.
SAFETY PRECAUTIONS
This product has been designed and tested in accordance with IEC1010-1/EN61010-1
including amendment 1(1995) for insulation category II use. Use of this equipment in a
manner not specified could result in personal injury.
AC POWER SOURCE:
This product is intended to operate from an ac power source
that will apply not more than 264 V ac between either of the supply conductors and
ground.
POWER CORD:
Use only the power cord and connector appropriate for the voltage
and plug configuration in your country. The cord must contain a safety ground conductor
and be connected to a plug that has a connection to earth ground. Use only a power cord
that is in good condition.
SIGNAL INPUT POWER:
Signals applied to the input or output terminals must be
limited to levels deemed safe by the IEC/EN specifications. When applied voltages are
above 30 volts, the current source must limit the current to not more than 2 milliamps.
