Customer Helpline
0333 3201989
9
Intended Use
This tool is intended for driving in and loosening screws as well as for drilling in wood,
metal and plastic.
NOTE:
Before using the tool, read the instruction book carefully.
1. CHARGING PROCEDURE
BEFORE PUTTING INTO OPERATION
CHARGING THE TOOL OR BATTERY PACK (SEE FIG A)
NOTE:
a) Do not use any charger other than that specifically provided for use with the equipment.
b) If the battery pack is very hot you must remove your battery pack from the charger
and allow time for the battery to cool down before recharging.
c) The battery in your new tool is not charged when it leaves the plant. Therefore it
must be full charged before using the first time
d) Please charge the battery to reach full or no less than half charge before storage. If
the tool will not be used for long periods of time, charge the battery every 3-6 months
1).Plug the charger into an appropriate outlet.
2).Place the battery pack into the charger
3).When charging is completed,unplug the charger and remove the battery pack.
Note: If the battery pack is locked in the charger, press the battery pack release
button and remove it.
WARNING:
When battery charge runs out after continuous use or exposure
to direct sunlight or heat, allow time for the battery to cool down before re-
charging to achieve the full charge.
Light
ON/OFF flash
Status
Red on
Charging
Red flash
- - - - -
Defective Battery
Green on
Fully Charged
Green flash
- - - - - -
Hot/Cold Delay
Operating Instructions
A
B
B
C
D
a
b
c
E
F
J2
H